Comet IoT Sensor plus W0841, Инструкция по эксплуатации

Страница: 10 / 31

10
ie-wfs-Wx8xxPlus-01
Device usage and settings
Factory setting

message sending interval of 10 minutes

alarms deactivated

remote setting enabled

for devices with pressure measurement set altitude 0 m (the device
displays absolute atmospheric pressure)
Working with the cloud _____________________________
Viewing measured values
Cloud is an internet storage of data. You need a PC with internet
connection and a web browser to work with. Navigate to the cloud address
you use and sign in to your account - if you use COMET Cloud by a
transmitter manufacturer, enter
www.cometsystem.cloud and follow the
instructions in the COMET Cloud registration document that you received
with your device.
Each transmitter is identified by its unique address (device ID) in the Sigfox
network. The transmitter has an ID printed on the nameplate along with its
serial number. In the list of your device in the cloud, select the device with
the desired ID and and start viewing the measured values.
Checking the signal quality during device installation
The device in factory default setting will send the measured values every
10 minutes. Check in the cloud for messages to be received. Place the
device temporarily to the location where it will perform the measurements
and check the quality of the radio signal - in COMET Cloud click on the
correct device in the
My Devices list and then select Installation . If you have
a problem with the signal, see the Problems with recieving radio messages
chapter.
Change of device settings remotely
The transmitter can be set remotely from the cloud if the cloud you use
supports this feature. Run the remote setting feature - in COMET Cloud
click on the correct device in the
My Devices list and then select Configure .
Set the desired sending interval (taking into account the fact that for short
sending intervals the battery life decreases), the limits, delays and
hysteresis of the alarms for the individual quantities (if used), or correction
of the altitude atmospheric pressure (only models with air pressure
measurement). Save the new setting. The device will accept this new
setting within 24 hours at the latest.
If you are running a new transmitter and want to speed up the setting, press
the CONFIGURATION button (the device must be switched on beforehand)
- the setting symbol (gears) lights up and the device will start
transmitting the new setting from the cloud within 10 minutes. The