Comelit HFX-7004M, Техническое руководство

Страница: 29 / 104

29
EN
4.8.2.3 FUNCTION 2: ACTUATOR WITH CODE MODE
√
NOTE: Before programming the module, see “4.9.2.4 COMPATIBILITY TABLE”
By pressing the button programmed as "coded actuator", it is possible to toggle between the different cameras.
Microswitch “ S1 ” must be set as shown in following table:
CORRESPONDENCE OF 1409 ADDRESS ACTUATOR WITH CODE ON BRACKET
DIP 1 DIP 2 DIP 3 DIP 4 DIP 5 DIP 6 Address 1409 Actuator on bracket code
1 0 0 0 0 0 0 220
1 0 1 0 0 0 1 221
1 0 0 1 0 0 2 222
1 0 1 1 0 0 3 223
1 0 0 0 1 0 4 224
1 0 1 0 1 0 5 225
1 0 0 1 1 0 6 226
1 0 1 1 1 0 7 227
DIP 1 DIP 2 DIP 3 DIP 4 DIP 5 DIP 6
Example of Address setting
on art. 1409 for control using actuator
code 224
1 0 0 0 1 0
In this mode, with the video entry phone monitor switched on, by repeatedly pressing the actuator with code pushbutton, it is
possible to cycle through ONLY the cameras connected to module 1409 with the corresponding address.
In the same system, it is possible to install up to 8 1409 modules with different codes.
4.8.2.4 COMPATIBILITY TABLE
COMPATIBILITY OF 1409 WITH 1256 OR OTHER 1409
Generic actuator mode Actuator with code mode
Compatibility with 1256 No 1256 in “Generic actuator mode”
No 1256 in “Actuator with code mode” with
codes between 220 and 227
Compatibility with 1409 No other 1409
Only 1409 in “Actuator with code mode” with
different codes