Setting range for the closing delay:
min : 1min
max : 250min
Hot-wire probe corrective coefficient setting.
The velocity probe consists of a wire heated at a temperature
higher than the ambient temperature.
Over time and depending on the using conditions, it can be
altered (like a light-bulb filament) and can lose accuracy. To
solve this problem, a corrective coefficient can compensate
the probe deterioration.
It can be modified by the installer.
To do so, proceed as follows : enter the menu as explained in
part 4.4.1.
Once in the menu, enter the sub-menu “probe calibration” by
pressing the button “ENTER”.
MENU
PROBE CALIBRATION
Once in the sub-menu “Probe calibration”, press buttons “+”
or “-“to select the coefficient desired.
(Default value : 128).
PROBE CALIBRATION
COEFF°: 128
When the desired value is reached, validate by pressing
button “ENTER”.
A screen appears confirming the modification of the value
PROBE CALIBRATION
MEMORISATION
To come back to the first screen, enter the sub-menu “Normal
mode” pressing buttons “+” and “-“ then, press button “ENTER
CAUTION : this value is calibrated by a qualified tech-
nician during the factory’s calibration phase.
Buzzer activation .
When the alarm is activated on the control device, the
buzzer is triggered to inform the user there is a default.
The alarm can be activated or deactivated as explained be-
low.
To do so, proceed as follows: enter the menu as explained
in part 4.4.1
Once in the menu, enter the sub-menu “buzzer activation”
pressing button “ENTER”.
BUZZER
ACTIVATION
Once in the sub-menu “Buzzer activation”, press buttons “+”
or “-“ to activate or deactivate the buzzer.
BUZZER
ACTIF
When the status desired is reached, validate pressing button
“ENTER”.
A screen appears confirming the modification of the value
BUZZER
MEMORISATION
To come back to the first screen, enter the sub-menu “Normal
mode” pressing buttons “+” and “-“ then, press button “ENTER
17
