Page 4 of 15
To redial once a minute for 10 minutes, press the ARDL button. The intercom light will flash. The
Intercom light flashes and you will hear either a ringing or busy tone over the monitor speaker.
Pick up the handset within 30 seconds to connect.
To cancel the automatic redial, lift and replace the handset or use the phone for another function.
Call Cost/Timer –
If enabled, you can press the cost button to display the cost of the current call. If call cost is not
enabled, press the timer button will show up as timer and will display the running duration of the
current call. To display the call time for the last call, press HOLD while the phone is idle. To show
the cost, press HOLD twice.
Intercom Calls –
Manually call a station by pressing the intercom button and dialing the extension number.
Automatically call by pressing the DSS button. These methods will cause that extension to ring.
To voice call - Manually call a station by pressing the intercom button, dialing the extension
number and speaking your announcement. Automatically call by pressing the DSS button and
speak your announcement.
Using Automatic Callback –
For intercom calls only. If the station you ring is either busy or ringing with no answer, you can
prompt the system to ring your phone when the extension you called becomes idle (when it was
busy) or when there is any activity on the extension (for no answer calls). This can also be used to
prompt a user whose line is in do not disturb to call you back when they are no longer in do not
disturb.
To use, make the intercom call and press CAMP. Your phone will disconnect from the attempted
call. When the phone you rang is available, your phone will ring with five ring bursts. Press
intercom to ring the other phone.
To use with calls made in the voice-announce mode, press intercom before the camp button.
To cancel, press intercom and dial “#6”.
Using Call Waiting –
To send a call waiting tone to a busy line and wait for an answer, press NEXT, then CWAIT and
remain on the line.
Overriding a call –
If the extension you call is busy or in do not disturb mode, you can break through using the
executive override function provided the feature has been enabled on your system.
To use, when you get a busy signal, press Next, then OVER. When you get a do not disturb signal,
press OVER to disable the mode on the called station and either speak your announcement (if your
phone is in voice-first mode) or wait for an answer (if your phone is in tone-first mode).
Using a Subdued Off-Hook Voice Announcement (SOHVA) to Interrupt a Call –
If this feature is enabled on your system, you can break in to a call in progress to speak with the
internal party.
To use, press the SOHVA button, wait for the tones and make the announcement. If you get a
