Page 11 of 15
To use, press INTERCOM and dial “*06”. To disable, press INTERCOM and dial “#06”.
Send a Call Back Message to a Station’s Tracker Pager after Receiving a Ring-No Answer
Response –
Dial “#01” or the preprogrammed TRACK button. When your station returns to idle, hang up or
press SPEAKER to end. Your extension number (and station name on some models) will be
displayed on the called party’s Tracker Pager display.
Send a Call Back Message to a Station’s Tracker Pager Without Calling Them First:
1. Press INTERCOM
2. Dial “#01”
3. Dial the extension number and hang up or press SPEAKER to end. Your extension number
(and station name on some models) will be displayed on the called party’s Tracker Pager
display.
Send a Message to a Station’s Tracker Pager to Retrieve a Parked Call:
1. Answer the call and press TRNS/CNF
2. Enter the extension number
3. Dial “#01” or press the TRACK button
4. Hang up or press SPEAKER to end. The Pager Tracker system sends the orbit dialing code
and available caller I.D. information to the display.
Respond When Your Tracker Pager Displays a Park Orbit Dialing Code –
Press INTERCOM from any extension, dial the orbit number to retrieve the call.
Auxiliary Jack on Model 80245 -
This jack allows for a headset, tape recorder, external pager or ringer to be connected to your
phone. One of your programmable buttons must be programmed to enable or disable each
auxiliary device that may be connected to your phone. Only one device may be enabled at a time
and the active device name will be displayed in your LCD.
Headset mode
allows you to use the headset instead of the handset or speakerphone. Lifting the
handset will disable the headset for that call.
Recorder mode
records your call.
External ringer
mode
uses an external speaker to sound your ring tone.
Pager mode
sends all voice
announcements sent to your phone to the external paging device. All modes except headset mode
require an external power source.
Program the Enable/Disable Buttons:
1. Press INTERCOM and dial “**1”
2. Press the programmable button
3. Dial a feature code (Headset – 94, External Ringer – 95, Tape Recorder – 96, External Pager
– 97). Press TRNS/CNF
4. Repeat to program all four buttons if needed
5. Press SPEAKER to end.
To use an Auxiliary Mode –
Press the programmed button to enable. The display shows the feature enabled. Press the
corresponding programmed button again to disable.
