Combi ANGEL WAGON AW Series, Инструкция по эксплуатации и руководство по осмотру, Страница: 29 / 32

Phillips
screwdriver
Phillips
screwdriver
Umbrella
holder
Nut
(attached to
the holder)
Cap nut
Wrench
Wrench
Screw M6 x 30 mm
(with a plain washer and
a spring washer)
Screw M6 x 25
mm
(with a plain
washer and a
spring washer)
Flange
nut
Installation AW4 Series (Rear facing type)
Install the umbrella ring following the removal procedure in the reverse order. Install new umbrella holder
1 2
Facing the product, install the umbrella ring above the
area where the frame and thin bar jointed on the right
handle.
Thin bar
Place the umbrella holder on the other side of
handle side and locate the support slightly outside.
* Make sure to use correct screw. The length of the screws for umbrella ring and umbrella holder are different.
Umbrella ring
Locking key
Red screw cap
Screw
In case you find a problem with the keychain or the coin lock
during the daily inspection, we recommend that you purchase a
keychain replacement kit or a coin lock replacement kit and carry
out the replacement following the procedure below.
Locking Key and Coin Lock Replacement Procedure <AW3 Series>
Locking Key Removal
Remove the red screw cap from the bottom of
the coin lock.
Remove the screw.
1 2
The tools on the right are
required for this procedure.
l
Phillips screwdriver
l
Precision flat blade screwdriver
Always inspect the new part after
replacement following the daily
inspection instructions.
Warning
28