* Only for AW3 Series (Forward facing type)
Front caster (ø100)
for escalator ramps
Rear caster (ø100)
for escalator ramps
3
Replacement Procedure of Casters for Escalator Ramps (
ø
100) and Safety Wheels
The tools on the right
are required for this
procedure.
l
Dedicated wrench
(21 and 23 mm)
×
1
l
Wrench (19 mm)
×
1
Front Casters
Rear Casters
1. While holding the hex cap nut in place with the wrench (19
mm), rotate the bolt counterclockwise using the dedicated
wrench (23 mm).
2. Remove the casters, the safety wheel and the washers.
1. Rotate the bolt counterclockwise using the dedicated wrench
(23 mm).
2. Remove the caster and the spring washer.
Install the caster following the removal procedure in the
reverse order and tighten it securely using the wrench.
Install the caster following the removal procedure
in the reverse order and tighten it securely using
the wrench.
l
Removal
l
Removal
l
Installation
l
Installation
Hex cap nut
Plain washer
×
1
Hex bolt
Dedicated
wrench
(23 mm)
Dedicated
wrench
(23 mm)
Hex bolt
Spring
washer
×
1
Spring washer
×
1
Front caster
(the casters for
the right and
left side differ)
Rear caster
(the casters for
the right and
left side differ)
Rear caster
Front caster
The stoppers must position inside.
The stoppers must
position inside.
Plain washer
×
1
Safety wheel
Wrench (19 mm)
Hex cap nut
Install the correct casters for the right and left sides. If
the casters are installed on the wrong side, the stoppers
will face outward and may be damaged if they hit a wall
or another object. *The same applies to the rear casters.
Caution
20
Содержание ANGEL WAGON AW Series
Страница 31: ...30...