22
WEEKLY MAINTENANCE
REPLACING THE REAR SQUEEGEE RUBBER
If the squeegee rear rubber is worn and does not dry well, it is possible to change the
drying edge, proceeding as follows:
1. push and rotate the fixing plates (1)
2. remove the rubber-pressing blade and the rubber itself
3. turn the rubber upside-down and, if necessary, replace it
4. reassemble everything, carrying out the above-mentioned operations in the
reverse order
5. adjust the height of the squeegee depending on the rubber (see “ADJUSTING
THE HEIGHT OF THE SQUEEGEE SUPPORT”)
REPLACING THE FRONT SQUEEGEE RUBBER
Suction will be poor and the machine will not dry perfectly if the front squeegee rubber
is worn. Proceed as follows to replace:
1. With the squeegee up, unthread the suction tube (1) from the squeegee sleeve (2)
2. Loosen the ring nut (3) until it touches the nut.
3. Push the squeegee to the left, unthreading the inclination adjustment column (4)
from the squeegee support seat.
4. Loosen the screws that clamp the front rubber
5. Remove the rubber-pressing blade
6. Pull out and replace the front rubber
Reassemble everything, carrying out the above-mentioned operations in the
reverse order
CLEANING THE SUCTION TUBE
Whenever suction seems to be unsatisfactory, check that the suction tube is not
obstructed. If necessary, clean it with a water jet introduced from the side where it is
connected to the tank. Proceed as follows:
1. Detach the aspiration tube from the seat (1) on the recuperation tank
2. Clean it with a water jet introduced from the side where it is connected to the tank
3. Reassemble everything, carrying out the above-mentioned operations in the
reverse order
ATTENTION!
This operation must be carried out using gloves to
protect against contact with dangerous solutions.
1
1
1
2
3
4
