19
AT THE END OF THE WORK
At the end of the work, and before carrying out any type of maintenance, perform the
following operations:
1. turn off the tap
2. set the “AUTO/MAN” switch on manual (yellow indicator light off)
3. switch off the solenoid valve switch
4. Switch off the suction motor switch
5. Lift the squeegee using the manipulator
6. Lift the base using the manipulator
7. Bring the machine to the place provided for draining the water
8. Turn the key a quarter of a turn counter-clockwise to turn the machine off
9. Disconnect the tube from its seat, unscrew the drainage cap and empty the
recovery tank.
ATTENTION!
This operation must be carried out using gloves to protect
against contact with dangerous solutions.
11. Clean the squeegee with a jet of water. The squeegee must be raised when the
machine is not operating, to avoid deforming the rubber blades. To facilitate the
cleaning of the rubbers, the squeegee can be rotated forwards.
12.
Disconnect the metal clamp (1) and remove the suction tube (2) from the
squeegee suction sleeve
13. Pull out the knob (3) and raise the support (4).
14. Rotate the squeegee forwards until it locks. The knob (3) will hook up to the
support (4) so as to stop the squeegee from moving back.
15. After cleaning the rubbers, bring the squeegee back to its initial position by pulling
the knob and rotating the support backwards until it is hooked.
1
2
3
4
