12
MACHINE PREPARATION
7. BATTERY CHARGE LEVEL INDICATOR
The digital battery indicator has 4 fixed positions and a flashing one. The numbers
which appear on the display show the approximate charge level.
4
= maximum charge,
3
= 3/4 charge,
2
= 2/4 charge,
1
= 1/4 charge,
0
= discharged batteries (flashing)
ATTENTION!
A few seconds after the appearance of the flashing “0”,
the brush motor will switch off automatically. With the remaining
charge it is possible to complete the drying process before starting the
recharge.
8. ASSEMBLING THE SQUEEGEE
For packaging reasons, the squeegee is supplied disassembled from the machine,
and must be assembled as shown in the figure. First threading left pin (1) of the
squeegee into the left slot on the arm and then right pin (2) into the right slot, being
careful to keep the spring and the washer above the arm’s flat bar. This can be
simplified by first loosening the handwheel on the pin. Then retighten the handwheel
to block the squeegee in place.
Insert the squeegee tube in the appropriate sleeve (3).
2
3
1
9. SQUEEGEE
INCLINATION
During working operation, the rear rubber is slightly tilted backwards (by about 5mm)
in a uniform way for its whole length.
If it is necessary to increase the bend of the rubber in the central part, you must tilt
the squeegee backwards, rotating the adjuster (1) anticlockwise. To increase the
bend of the rubber at the sides of the squeegee, rotate the adjuster (1) clockwise.
10. ADJUSTING THE SQUEEGEE SUPPORT HEIGHT
The height of the squeegee must be adjusted on the basis of the state of wear and
tear of the rubber. To do this, turn the knob (2) clockwise (tighten) to raise the
squeegee, and anticlockwise (unscrew) to lower it.
Note:
the right and left wheels must be adjusted to the same level, so the squeegee
can work parallel to the floor.