Columbus step 110, Руководство по эксплуатации, Страница: 19 / 36

step 110
19
The pre-selected programme can now be started. When the cleaning cycle has been com-
pleted, the machine is raised (Fig. 9: Raising the machine).
When raising the machine, the operator must ensure that the glide rails do not
hang on the inside walls of the escalator.
Figure 10 Raising the machine
The machine is then shoved forward again until the wheels stop on the next highest step
(Fig. 4: Fixing the machine), and then lowered again. The machine can now be shoved on
the glide rails into the new working position (Fig. 9: Positioning the machine).
Repetition of the procedure described above will allow the escalator to be cleaned from the
bottom to the top completely-extended step.
Always ensure that the power cable is disconnected and wound up before the
escalator is started again to avoid accidents!
The switched-off and lowered machine is then driven downwards with the escalator to the
position of the last extended step.
After the cable has been connected once more, the procedure described above can be start-
ed anew and the escalator cleaned again up to the top completely extended step. After the
machine has been run from the lower to the highest completely extended step, one side of
the escalator will have been cleaned.
The machine must now be shifted from the left to the right (Fig. 11: Shifting the machine).
Therefor lift the machine about 3 to 5 cm and push it on the gliding rails to the other side.
Do not push the machine on the gliding rails! They can be ruined.