Columbus McKinnon Yale ERGO 360, Руководство по эксплуатации, техническому обслуживанию и каталог запасных частей

Страница: 14 / 64

14 COLUMBUS McKINNON
Hooks that do not fulfil all requirements must be replaced immediately. Welding on hooks,
e.g. to compensate for wear or damage is not permissible. Top and/or load hooks must be
replaced when the mouth of the hook has opened more than 10% or when the nominal
dimensions have reduced by 5% as a result of wear. Nominal dimensions and wear limits are
shown in table 3. If a limit value is reached, replace the components.
Nominal values and wear limitation
Yale ERGO 360 800 1600 3200 6000 9000
Hook opening
a
nom
[mm] 27,0 31,0 40,0 44,0 68,0
a
min
[mm] 29,7 35,2 44,0 48,4 74,8
Hook width
b
nom
[mm] 15,0 19,5 20,0 32,0 50,0
b
min
[mm] 14,3 18,5 19,0 30,4 47,5
Hook height
h
nom
[mm] 20,0 26,0 37,0 45,0 68,0
h
min
[mm] 19,0 24,9 34,8 42,6 64,6
Inspection of the brake
Immediately contact the manufacturer, if irregularities are found (e.g. defective friction disks).
All components of the brake must be checked for wear, damage, discoloration caused by
overheating and for functioning.
Friction disks must always be kept free from grease, oil, water or dirt. Check the bonding of
the friction disks.
The inspections have to be initiated by the operating company.