COLUMBIA VAC KLC12000, Руководство пользователя

Страница: 23 / 28

EN
•
23
Press the " A " button - the digits on the " E " display will start blinking.
Using the "
C
" and "
H
" buttons, select the time within the range 1 to 24 hours.
After selecting the time, wait until the digits on the display stop blinking.
Activation of the function is indicated by the indicator light "
K
".
To deactivate the function, press the "
A
" button twice.
When switched on, the air conditioner will operate in cooling mode according to the
previous temperature and fan speed settings.
TIMER
Switch on the device with the " J " button.
Select the desired operating mode (see above).
Press the "
A
" button - the digits on the "
E
" display will start blinking.
Using the "
C
" and "
H
" buttons, select the time within the range 1 to 24 hours.
After selecting the time, wait until the digits on the display stop blinking.
Activation of the function is indicated by the indicator light "
K
".
To deactivate the function, press the " A " button twice.
It is possible to change the operating mode when the " TIMER " function is active.
WATER DISCHARGE
The unit is equipped with an evaporation system. Liquefied water is used to cool the
condenser, which increases the cooling efficiency and reduces energy consumption.
If the amount of water in the system reaches the maximum level, the "
D
" indicator on the
control panel lights up, and the compressor stops working.
Manual removal of water – drawing 6.
Switch off the device and move it to a place where water can be drained from it.
Remove the plug from the hole "
14 " and carefully drain the water.
Insert the plug into the hole " 14 ".
Turn the device on again.
Constant water drainage – drawing 7.
Turn the appliance off.
Remove the plug from the hole "
10
".
Mount the rubber tube (not included) and place its other end in a container, e.g. a bucket.
MAINTENANCE
Note: Turn off the unit and unplug it before any maintenance or repair begins to avoid
electric shock.
Cleaning
· Unplug the unit before any cleaning.
· Clean the housing with a soft moisture cloth. Do not use chemical solvent (such as
benzene, alcohol, gasoline). The surface may be damaged or even the whole case may
be deformed.
· Do not sprinkle water on the unit.