HEATER HIGH-LIMIT PROTECTION SYSTEM
Your spa is equipped with an high limit/ over heat protection system. The system will shut the heater down if the
temperature at the heater has reached 119°F (48°C).
Do not enter the water!
Turn off the power, remove the
spa cover and allow the water to cool down. After water has cooled down power your spa up again to reset the
system. If the high limit protection system is activated repeatedly, do not use your spa until the problem has
been corrected. Contact your local spa dealer to correct this problem.
AIR CONTROL VALVES
Air control valves will help enhance your jet experience by injecting air into the water stream giving the jets
increased performance. To activate, locate the air control valves located a the top rail of your spa. Turn the
valve until you to achieve the desired jet performance.
ADJUSTING THE JETS
Your spa is fitted with adjustable, fully directional hydro-jets. The jet action can be directed by aiming the swivel
ball nozzle. The water flow through some jets can be regulated turning the jet face clockwise or counter-
clockwise.
UNDERWATER SPA LIGHT
Your spa is equipped with an underwater spa light located in the spa interior. The low-voltage 12-volt system
produces a bright white light for use in the spa, and makes entering the spa safer. The light control switch is
located on the spa control panel. To replace a burned-out bulb, open the equipment bay door to find the spa light
housing attached to the spa side. Remove the lamp socket from the back of the light assembly by turning and
pulling at the same time. Gently pull the bulb out of the lamp socket, and replace with a similar bulb available
from your spa dealer. Installation is reverse of removal.
SPA SURROUND MAINTENANCE
Your spa has either the “Eco-wood” low maintenance siding or natural cedar siding. The Eco-wood siding is very
low maintenance. If the Eco-wood needs to be cleaned a spray from a garden hose or light to medium spray
from a pressure washer will work fine. A soft cloth or towel can be used to wipe the siding as required. The
natural cedar skirting should be stained annually with an exterior-grade wood treatment for weather protection. If
cleaning is required caution should be used with a pressure washer as not to damage the wood.
GENERAL SPA CARE
To avoid damage to the heater and pump, the spa support system must never be run without water in the spa.
Inspect or clean the filter cartridge weekly (or as needed). Clean it more often during frequent spa use. A dirty
filter inhibits the water flow, thereby reducing the jet action, the efficiency of the heater, and could damage the
pump seal.
DO NOT COVER YOUR SPA WITH ANY TRANSPARENT OR PLASTIC COVER.
Clear "solar blankets" are not recommended because they can create a solar oven effect that could cause
structural warping, blistering, fading of the acrylic surface and jet damage and will void your warranty.
SERVICE RECORDS & NOTES
