Columbia ParCar Expediter EX21-24A, Руководство по обслуживанию

Страница: 82 / 94

Section 9
–
Battery and Battery Charge
r
qualified dealer technician. A STEADY RED FAULT LED
confirms an internal electrical fault of the Delta-Q, and also
requires charger replacement and return.
REPLACING BATTERIES
The batteries are located under the seat.
REMOVING BATTERIES
1. Remove nuts, washers and cables, positive lead and
negative lead interconnecting batteries.
2. Remove nut, flat washer, hold down plate and rod.
3. Remove batteries.
INSTALLING BATTERIES
1. Install batteries.
2. Install rod and hold down plate.
3. Install flat washer, nylock nut.
4. Install nuts, washers and cables, positive lead and
negative lead interconnecting batteries.
BATTERY CHARGER
REMOVAL
NOTICE: There are four wires in the output lead from
the charger; black and white together to battery B-; red
wire to battery B+; green wires to connector on red wire
#14 on the interlock circuit. The black and white wires
at battery B- are terminated in a thermistor. Take extra
care when handling the thermistor.
1. Disconnect 4 wires in charger output lead from battery B-
, battery B+ and wire 14. Unplug power inlet cable from
charger pigtail.
2. Remove four nuts, four washers, four bolts and charger.
See Figure 9-5.
Figure 9-6
INSTALLATION
1. Position new charger to mounting bracket.
2. Secure new charger with four nuts, washers and bolts.
Tighten charger attaching hardware.
3. See Figure 9-6. Install charger output electrical leads as
follows; black and white to battery B-, red wire to battery
B+, green wire to red wire #14 from interlock harness.
Plug in cord from power inlet to charger pigtail. Tape the
two plugs together so they cannot accidentally separate.
4. Bundle up the excess charger output cable and secure it
neatly with wire ties.
5. Reconnect battery negative cable. Install Power key.
6. Power key ON. Check BDI display.
Figure 9 - 5