Electrical Connection
NOTE: Supply lead wires should not be connected to a dimmer of any sort.
Installing Your Color Ray Receiver
1. Prepare Wires:
Note: Make sure the low-voltage wiring is installed at the wall box that
will house the Color Ray receiver.
•
Be sure that the ends of the wires from the wall box are
straight—cut if necessary.
•
Remove 5/8” or 1.6 cm of insulation from each wire in the wall
box.
2. Connect CAT5/RJ45 Cable to Receiver Coupler
3. Connect Power
Connect the line voltage (120V) wires in the following manner:
Screw the wire nuts clockwise so that no bare conductors show
below the wire connectors. Secure each connector with the
electrical tape.
•
Green dimmer Ground lead to Green or bare copper wire in
wall box.
4. Test the Color Ray Receiver prior to mounting in wall box:
•
Restore the power at the circuit breaker or fuse.
•
Turn remote on to test.
•
If the lights still do not turn on, refer to the troubleshooting section.
Page 8—Coloronix Color Ray Manual V1.0