Colorjet Vulcan Prime, Руководство пользователя

Страница: 17 / 47

Page 16 of 46
Vulcan Prime
Parameter Settings
Push the Set button for 5 seconds to read the parameter setting. Push the + - button to adjust the data, then push
the Set button to confirm the adjustment.
Code Setting Contents Default
HC Work Mode H
P7 Temperature Correction (
0
C) O
CA Start-Up Delay (Seconds) O
HS Upper Limit of Temperature (
0
C) 50
LS Lower limit of Temperature (
0
C) 5
D Return Difference (minutes) 5
Push the Set button to set the default to be 50.
•
Winter Mode (Constant temperature mode, default is 26
0
C): The middle screen displays the current
setting temperature that can be changed using the + - button.
Water temperature (D1) = setting temperature (D2) + D - values(C1)
The setting range is 5-40
0
C, the default is 30
0
C. In addition, the setting temperature can’t exceed the range
of C4 – C5.
•
Summer Mode (Intelligent Mode, Default: 1
0
C): The middle screen displays the D-value of water
temperature and indoor temperature, press the + - button can change it. The setting range is (-5~+5
0
C).
Water temperature (D1) = Indoor temperature(D2) + D – values (C1)
D1 will display upper limit (C5) and lower limit (C4) value if room temperature is too high or too low to
beyond the upper or lower limit. For example: D2=1
0
C, indoor temperature is 25
0
C, so D1=26
0
C+C1, as
C1=1.5
0
C in default. So, the water temperature D1 should control in 24.5 ~ 27.5
0
C.
Other Instances
•
Whether in winter mode or summer mode, the chiller will stop refrigeration when the water temperature
lower than C4-0.5
0
C and will return to normal control when the water temperature higher than C4 + 0.5
0
C.
•
The heating wire start to work when the water temperature lower than C6 – 0.5
0
C and will stop work
when the water temperature higher than C6 + 0.5
0
C.
•
Press the Set button to enter the setting mode, no operation for more than 10 seconds and press the Set
button again to exit the setting state.
o
Press the Set button for 4s to restore the factory setting in the setting mode.
o
Press the switch to change the setting item, press the + - button to modify the parameter value
of the item.
o
D1 will show the item code, D2 show the parameter value and the D3 shows value remains same.