3.
3.
3.
3. Operation
Operation
Operation
Operation Instructions
Instructions
Instructions
Instructions
-The moving head is for beam effect for onsite decoration purpose.
-Don’t turn on the fixture if it’s been through severe temperature difference like after
transportation because it might damage the light due to the environment changes. So make sure
to operate the fixture until it is in normal temperature.
-This light should be keep away from strong shaking during any transportation or movement.
-Don’t pull up the light by only the head, or it might cause damages to the mechanical parts.
-Don’t expose the fixture in overheat, moisture or environment with too much dust when installing
it. And don’t lay any power cables on the floor. Or it might cause electronic shock to the people.
-Make sure the installation place is in good safety condition before installing the fixture.
-Make sure to put the safety chain and check whether the screws are screwed properly when
installing the fixture.
-Make sure the lens are in good condition. It’s recommended to replace the units if there are any
damages or severe scratch.
-Make sure the fixture is operated by qualified personnel who knows the fixture before using.
-Keep the original packages if any second shipment is needed.
-Don’t try to change the fixtures without any instruction by the manufacturer or the appointed
repairing agencies.
-It is not in warranty range if there are any malfunctions from not following the user manual to
operate or any illegal operation, like shock short circuit, electronic shock, lamp broke, etc.
4.
4.
4.
4. Mounting
Mounting
Mounting
Mounting and
and
and
and Installation
Installation
Installation
Installation
Cautions:
Cautions:
Cautions:
Cautions:
For added protection mount the fixtures in areas outside walking paths, seating areas,
or in areas were the fixture might be reached by
unauthorized personnel.
Before mounting the fixture to any surface, make sure that the installation area can hold a
minimum point load of 10 times the device’s weight.
Fixture installation must always be secured with a secondary safety attachment, such as an
appropriate safety cable.
Never stand directly below the device when mounting, removing, or servicing the fixture.
6
Gobo
0-009
Open/White
010-019
Gobo 1
020-029
Gobo 2
030-039
Gobo 3
040-049
Gobo 4
050-059
Gobo 5
060-069
Gobo 6
070-079
Gobo 7
080-099
Gobo 1 shake slow to fast
100-119
Gobo 2 shake slow to fast
120-139
Gobo 3 shake slow to fast
140-159
Gobo 4 shake slow to fast
160-179
Gobo 5 shake slow to fast
180-199
Gobo 6 shake slow to fast
200-219
Gobo 7 shake slow to fast
220-255
Rot. gobo wheel cont. rotation slow to fast
7
Shutter
0-031
Shutter closed
032-063
Shutter Open
064-095
Strobe effect slow to fast
096-127
Shutter Open
128-159
Pulse-effect in sequences
160-191
Shutter Open
192-223
Random strobe effect slow to fast
224-255
Shutter Open
8
Dimmer
0-255
Dimmer 0%...100%
9
Prism
0-005
Prism swing out
006-127
Prism swing in
128-189
Forward rotation from fast to slow
190-193
Prism rotation stop
194-255
Backward rotation from slow to fast
