Collomix VIBA X.30, Инструкция по эксплуатации

Страница: 12 / 21

Shaker VIBA X.30 Collomix GmbH
D-85080 Gaimersheim
12 Version 1.0-20
6. Operation
Prior to working with the machine, check all parts for their proper condition and function. Do not
start the machine with defective or missing parts.
Check all safety-relevant structural components of the machine for proper function before starting
it. Any defective or damaged parts must be replaced by qualified personnel prior to starting to work
with it.
6.1 Switching on the machine
The machine is turned on using the main switch (1). After an automatic initialisation, START is shown
on the display.
Any errors detected during initialisation are shown in text form on the display.
6.2 Load a container
Only use sufficiently stable and tight-closing vessels for mixing. In case of doubt, consult the
manufacturer of the mixing vessels.
To place the container, proceed as follows:

Unlock and open the door by pushing the DOOR button.

To adjust the mixing unit to the height of the container, use the E-Button to raise the clamping
plate.

Observe the weight and size limits of the mixing vessel. Never overload the machine!

Place the container centrically on the mixing table and secure the container handle with a
rubber band or an adhesive.

Use only undamaged containers, never stack containers!

Several identical containers can be mixed at the same time. Pay attention to a symmetric
arrangement of the containers on the mixing plate.

Close the door.
IMPORTANT
If you use larger containers, it is recommended to insert an additional filler disk made of foam.
However, the filler disk should not be higher than the rim of the cover. It reduces the membrane
effect of the cover and the running noise is reduced.
Place containers always in the centre.
Do not stack containers!
Filler disk
Securing the handle with
a rubber band