Coinco CoinPro 3, Руководство по эксплуатации и обслуживанию

Страница: 14 / 28

Page 14
PROCEDURE RESULT FUNCTION VERIFIED
Turn tester power OFF. Remove Upon power up, the High Tube Sensor
acceptor from changer. Block digital display and tube sensors
the coin change high tube sensors upper and lower LED's sequence.
by completely filling tubes with Coins are accepted and directed to
coins or by inserting a rolled up cash box, digital display will read
tube of paper into the three coin b.05, b.10, b.25 respectively and
tubes. Replace acceptor, turn tube sensors upper and lower
tester power switch on and LED's will illuminate
insert (1) nickel, (1) dime and (1) quarter
Insert (1) $ coin
$ coin is rejected No $ accept switch
Insert a Canadian nickel, dime Coin is rejected U.S. coins only or
quarter coin switch
Set changer coin Digital display will read rSt
control option switches as follows:
#1: (ON) Not Used.
#2: (ON) Lo $.25 Change tube
#3: (ON) $ coin accept
Actuate changer reset switch
Insert (1) $ coin
Coin is accepted and directed to
cash box, the digital display will
read b1.00
Block the middle $.25 change tube Quarter is accepted and directed to Middle $.25 tube sensor
tube sensor without blocking the the cash box. The digital display
high tube sensor by partially filling will read b.25 and the upper and
$.25 change tube with coins lower tube sensor LED's will
(approx. $5.00) or by inserting a illuminate
rolled up tube of paper far enough
into $.25 change tube past the high
sensor but far enough into tube to
block the middle sensor. Insert (1)
quarter.
Section 5: Bench Check Procedure
BENCH CHECK PROCEDURE