Installation Manual
3.0 Safety
8
3.0 Safety
3.1 Instructions
Installation must be done by qualified installers, and conform to all local codes and regulations.
All servicing must be performed by qualified service personnel. Procedures in this manual do not
require entry into the housing of the camera system. The unit contains sensitive devices that can be
damaged by static discharge. To reduce the risk of electric shock and damage to the unit by static dis-
charge do not perform any servicing other than described in these instructions. If the unit is defective,
please contact the Customer Service Department for technical assistance.
It is the user’s responsibility to ensure that the mounting methods are safe and adequate for the loc-
ation.
Use only stainless steel (SS) hardware to fasten the mount to an outdoor surface.
Warning: Do not remove the covers or housing. There are no user-serviceable parts inside.
Warning: The Schrader Valves on the camera head's back plate are for factory use only. Do not attempt to
add any gas to the camera head.
Warning: PoE++ (Power over Ethernet) injectors used with this camera system may operate from 100-240
V. These voltages are dangerous. Use extreme care working with equipment connected to these voltages.
Note: NFPA 70 (Articles 800.30 and 830.30), National Electric Code
®
requires that a listed primary
protector be installed on the conductors of outdoor communication circuits entering a premises, as close as
possible to the point of entrance. The primary protector must be appropriate to the circuit type (PoE, PoE++,
or Ethernet).
Warning: Voltages that present a shock hazard may exist on PoE circuits. Use caution to avoid direct
contact with exposed, bare Ethernet circuit conductors or connector contacts.
Warning: Some models of this camera system operate from 120 Vac or 24 V. Use care working with
equipment connected to 120 Vac or 24 V.
Warning: The camera system is operated via remote computer control and may move rapidly and
unexpectedly. Remove power from the camera system before servicing and whenever working near the
camera system.
Warning: Do not use y-cables or other non-standard wiring schemes.
Caution: In order to prevent damage or deterioration of the optical system avoid pointing the camera system
directly toward the sun.
