Installation Manual
11.0 Installation
29
11.2.3 Pole Mount Installation
Use the mount adapter, wall mount, and large pole mount for installation to a pole.
11.3 Installation Procedure
Provisions must be made for routing the system cable up to the camera system location:
Pole: If the cable routes up through the pole, support the cable inside the pole to strain relieve the cam-
era connector.
The sequence of installation can vary from site to site:
Verify that the system cable is accessible for connection to the camera system connector at the mount-
ing location.
If installing the dome to:
o
The wall: Use the mount as a template. Mark and drill holes in the mounting surface. Drill a hole
for the cable if required. Position the wall mount over the mounting holes. Secure with four 5/16”
fasteners (not supplied).
o
The pole: Position the pole mount on the pole and secure with the stainless steel mounting
straps (supplied). Use a flat blade screw driver or 5/16” socket (not supplied) to tighten strap
screws. Attach the wall mount to the studs on the pole mount and secure with the 5/16-inch
nuts and washers (supplied).
Install the dome
(Instructions on the Quick Disconnect disassembling/reassembling)
:
o
Remove the safety strap from the top half of the Quick Disconnect (the half with the threaded
nipple attached). Use 5/32” hex key.
o
Loosen two lock bolts on the Quick Disconnect with a 5/16” socket approximately 1/4”. Do not
remove lock bolts. Separate the two parts of the Quick Disconnect by rotating approximately
1/16 turn CCW.
o
Apply anti-seize compound on Quick Disconnect nipple threads.
o
Thread the Quick Disconnect nipple into the mounting arm and tighten with a strap wrench (not
supplied).
o
Tighten the set screw on the mounting arm securely.
Caution: Do not use the cable to support the weight of the camera.
