Installation Manual
9.0 Waterproof Coupler Assembly
24
2. If the RJ45 plug has a strain-relief boot, push it away from the RJ45 plug. The strain-relief boot will not
be used.
3. Pass the cable through the Sealing Nuts (1)
4. Pass the cable through the Sealing Collar (3).
5. Insert the Washer and the Two-Way RJ45 Port (5) in the Coupler Body (3) (if disassembled).
6. Insert the RJ45 plug into the Coupler Body (3).
7. Attach the Sealing Collar (6) to the Coupler Body (3). Make sure it is tightened completely.
8. Select the desired Seal (2) and press to open notch.
9. Insert the Seal (2) onto the cable with the recessed surface facing the Sealing Collar (6), then
push the Seal (2) all the way into the Sealing Collar (6).
The Seal (2) should sit completely flushed inside the fingers of the Sealing Collar with edge not
protruding.
