Installing the MVS-8100M
1
12
Cognex MVS-8100M Hardware Manual
Figure 1.
PCI slot types
4.
Select the source of +12 V power for the cameras and board by positioning jumper
J3.
Figure 2 shows the J3 jumper position for internal power from the PCI bus. Use this
setting only if you are sure you will connect no more than one camera to the 8100
and will not add cameras later, and you are not using a light control module. The
total available draw for all cameras and light modules with J3 in the 1-2 position is
about 750 mA.
Figure 2.
J3 jumper position for internal camera power
Back of
PC
Fro
n
t of PC
5 volt k
e
y
3.3 volt
key
3.3 volt
key
5 volt k
e
y
64-bit PCI or PCI-X slots
32-bit PCI slots
key
J3 Jumper with pins 1-2
1
1
covered for internal
camera power
