Cognex In-Sight 5000 Series, Руководство по установке

Страница: 25 / 48

5603, 5600 and 5605 Vision System Specifications
Table 3-3: 5603, 5600 and 5605 Vision System Specifications
Specification 5603/5613 5600/5610 5605/5615
Minimum Firmware
Requirement In-Sight version 4.4.3 In-Sight version 4.4.1
Job/Program Memory 128MB non-volatile flash memory; unlimited storage via remote network device.
Image Processing
Memory 256MB SDRAM
Sensor Type 1/1.8-inch CCD 1/3-inch CCD 2/3-inch CCD
Sensor Properties 8.8mm diagonal, 4.4 x
4.4µm sq. pixels 5.92mm diagonal, 7.4 x
7.4µm sq. pixels 11.01mm diagonal, 3.45 x 3.45µm
sq. pixels
Maximum Resolution
(pixels)
1
1600 x 1200 640 x 480 2448 x 2048
Electronic Shutter
Speed 27µs to 1000ms 32µs to 1000ms 28.8µs to 1000ms
Acquisition Rapid reset, progressive scan, full-frame integration.
Bit Depth 256 grey levels (8 bits/pixel).
Frames Per Second
2
14 full frames per second. 60 full frames per second. 16 full frames per second.
Lens Type C-mount
Lens Cover View Port
Material Clear plastic with an abrasion-resistant coating on the exterior side.
Trigger 1 opto-isolated, acquisition trigger input. Remote software commands via Ethernet and RS-
232C.
Discrete Inputs None built-in. Additional inputs available using a compatible I/O module. (For more
information, refer to
I/O Modules on page 4
.) Unlimited inputs when using an Ethernet I/O
system.
Discrete Outputs 2 built-in, high-speed outputs. Additional outputs available using a compatible I/O module. (For
more information, refer to
I/O Modules on page 4
.) Unlimited outputs when using an Ethernet
I/O system.
Status LEDs Power, Network Status, Network Traffic, 2 user configurable.
Network
Communication 1 Ethernet port, 10/100/1000
3
BaseT with auto MDIX. IEEE 802.3 TCP/IP protocol. Supports
DHCP (factory default), static and link-local IP address configuration.
1588 Support
4
Timestamp Resolution: 8ns
Synchronization Accuracy Through Transparent Clock: 5µs
Serial Communication RS-232C when connected to the Breakout Cable or a compatible I/O module. (For more
information, refer to
I/O Modules on page 4
.)
Power Consumption 24VDC ±10%, 600mA maximum.
Material Die-cast aluminum housing.
Finish Painted/Powder coat (back plate).
1
The number of image sensor rows are configurable and can be set within the In-Sight Explorer software. Decreasing the number of rows will
increase the number of frames per second acquired by the vision system. Refer to the AcquireImage topic in the
In-Sight
®
Explorer Help file
for more information.
2
Maximum frames per second is job-dependent, based on the minimum exposure for a full image frame capture using the dedicated acquisition
trigger, and assumes there is no user interface connection to the vision system.
3
To ensure reliable communication using 1000 BaseT operation, the Ethernet cable must not exceed 75 meters (from the vision system to the
endpoint).
4
1588 is only supported on vision systems running firmware version 4.5.0 and higher.
Specifications
13