Cognex In-Sight 3D-L4000 Series, Руководство пользователя

Страница: 8 / 16

Laser Safety Warnings
l
Do not stare into the beam.
l
Do not view directly with optical instruments (magnifiers).
l
Do not place optical components (mirrors) into the beam.
l
Design test fixtures in such a way that unintentional viewing of the beam is
prevented.
l
Switch off the laser when not in use.
l
Avoid the use of highly reflective materials. If you cannot, try to angle the
part so unintentional viewing of the reflection is prevented.
l
Terminate (block) unused beams.
l
Keep the laser plane horizontal or pointing downwards.
l
Report any issues that may have an impact on laser safety to your
supervisor or Laser Safety Officer.
l
There is no scheduled maintenance necessary to keep the product in
compliance.
l
Under no circumstances should you operate the sensor if it is defective or
the seal damaged. Cognex Corporation cannot be held responsible for any
harm caused by operating a faulty unit.
l
Under no circumstances should you modify in any way the sensor or its
housing.
l
Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
l
When moving the unit from a very hot environment to a cold environment
please allow the unit to equalize in a room temperature environment for 2
hours between temperature extremes.
8