Cognex In-Sight 1400, Инструкция по установке и справочник

Страница: 18 / 58

Installation
4
To connect a 1400 I/O Expansion Module:
1. Verify that any 24VDC power supplies are switched off.
2. Determine which device will be connected to each input and output. Common wiring
configurations are shown in
Appendix C . Refer to section 3.3 on page 18 for
connector and terminal block pin assignments.
3. Use a screwdriver to loosen the appropriate screw terminals.
4. Insert the signal and ground wire leads from remote I/O devices into the appropriate
positions on the terminal block, as shown in
Figure 2-1 .
5. Tighten the screw terminals with the screwdriver to secure the wire leads in the
terminal block.
Figure 2-1: Connecting I/O Wires
6. Plug the I/O module cable (DB15 connector) into the expansion module, as shown
in
Figure 2-2 .
Note:
The 1400 I/O Expansion Module outputs labeled HS OUT 0 and HS OUT 1 correspond
to the In-Sight 3400 and 5000 series sensor's built-in outputs. These signals are
considered
high-speed because they pass directly through the expansion module
without processing or optical isolation with minimal delay.
INPUT 1
OUT 2
OUT COMMON
IN COMMON