28 DataMan 500 Quick Reference Guide
DataMan 500 Quick Reference Guide 29
Training the Reader
Training your reader with the expected symbology can decrease the time
required to decode successive symbols. To train your reader, first switch
to Single mode, then place a code in front of the reader and do one of the
following:
• Press and hold the trigger button for a
minimum of 3 seconds.
• Click and hold the trigger button in
the Setup Tool for a minimum of 3
seconds.
• Click
Train Code
in the Results Display pane.
You can now switch to Burst, Continuous or Self trigger modes if necessary.
NOTE
that only a single symbol of each symbology kind can be trained.
Training Feedback
The middle LED on the reader glows green to indicate that
it is currently trained, or yellow to indicate that it is not
trained.
Connect the reader to the Setup Tool to untrain it and
allow it to recognize other enabled symbologies.
Incremental Training for Multiple Symbologies
If you want to train the reader to recognize multiple symbologies, you
can present a single image showing all the desired symbologies and
perform the training procedure previously described.
If you cannot present a single image showing all the necessary
symbologies, you can enable incremental training on the
Training
tab
of the
Symbology Settings
pane:
With incremental training enabled, you can train the reader using
multiple images showing the symbologies you expect to decode. The
reader will train each new symbology while retaining the existing
trained symbologies.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
