Coffee Queen MOCCA BTB, Руководство по обслуживанию

Страница: 21 / 34

21
.
14. Maintenance instructions grinder. Mocca BTB
B
B
A
A
3. Every month.
Approximately every week the grinder housing and spout should be inspected for
coffee residues and obvious damages. In case of too much coffee residues around the spout,
check if the silicone flapper inside the spout is in place.
Proceed as follows:
3.1
Remove bean container. Remove all coffee residues from the spout and the grinder
housing by grinding through all coffee beans and using a vacuum cleaner to remove all
residues.
3.2
Remove the three Allen screws (A) in the grinder housing lid.
3.3
Carefully detach the grinding housing. Fig.1.
Note its position for correct reassembly.
Do not alter the adjustment of the grinding
discs.
Fig.1.
3.4
Clean the inside of the grinder housing and the outside of the disc carrier with a soft brush.
Check the correct position of the silicon flapper and the spout.
(see chapter 6 and 6.5)
3.5
When reassembling the grinder housing, again check for the correct position and do not
alter the grind adjustment of the discs. Fasten the three Allen screws.
4. Removing the rotating carrier.
Each third year or after 50000 cups the grinding discs should be exchanged
to guarantee constant grinding capacity and accurate dosing.
Proceed as follows:
4.1
Remove the grinder casing and the rotating carrier. Loosen the left threaded nut by turning it
clockwise (A ) Fig. 2.
4.2
Remove the worn-out grinding discs by detaching the slotted screws. (B) Fig.2.
Fig.2.