Important
Do not do anything to the water dispenser. Inappropriate action can lead to personal injury and
faults.
The water dispenser should stand on a level surface to work satisfactorily.
The water dispenser must be placed on a waterproof surface so that any water leakage is visible.
Make sure that kinks are not formed in the connection hose during installation or when the water
dispenser is pushed into place. The machine’s supply and drain connection shall be checked
regularly. Check that no leakage has occurred in connection with installation.
The water connection always presents a risk of leakage irrespective of safety equipment.
The water dispenser must be completely drained of water if it is going to be stored for a long time.
Turn off the water tap if the machine is not going to be used for a long time.
Disconnect the machine from the electricity supply before doing any work on it.
This can be done by pulling out the plug from the wall socket.
CHILLER SYSTEM
INSTALLATION AND LOCATION:
The system is designed for use in standard environments according to CCN standard 33 2000-3
and is included in climate class N.
It must not be located close to a heat source or be subjected to direct sunlight.
The system is designed for use in an ambient temperature of no lower than 6°C and no higher
than 28°C.
The system must not be used or placed in an ambient temperature that is lower than 0
o
C.
ELECTRICAL CONNECTION
Connect the system to 220–240 V, 50 Hz and 10 A. The contact for electrical installation shall
comply with the current CSN regulations, EN and ISO standards. If the cable is damaged, it
must be replaced by a qualified person. This is to prevent an accident.
CONNECTION AND SERVICE:
The condenser shall be cleaned every 6 months in connection with water filter replacement.
Use compressed air when cleaning.
Carry out cleaning only once the power supply is disconnected from the chiller!
All installation work must be done by a qualified person.
7. Important.
WATER LINE
11.
