Page 3 of 6
FIGURE 4
FIGURE 5
TOP VIEW
SIDE VIEW
Standard Mounting without Shroud:
MOUNTING WITH VHB TAPE:
1. Carefully remove the light head from the shroud.
CAUTION: gently release the locking tabs to avoid breaking the tabs shown in
Figure A .
2. Clean the light head brackets with supplied alcohol wipe.
* for extra adhesion, see notes below.
3. Remove one side of the adhesive liner & apply to both brackets. Apply light pressure
for 20 seconds.
4. Insert bracket as shown on Figure B.
5. WITHOUT removing the second adhesive liner, hold the product to desired location.
Adjust the light head to its desired angle by adjusting the bracket.
6. Clean mounting surface with supplied alcohol wipe.
*for extra adhesion, see notes below.
7. Remove the second adhesive liner.
8. Apply product on to the treated surface. Apply light pressure for 20 seconds.
9. Insert the provided screws in the light head locking mechanism as shown in Figure C.
This will hold the brackets in position & the light head in the desired angle.
MOUNTING WITH SUCTION CUP:
1. Carefully remove the light head from the shroud.
CAUTION: gently release the locking tabs to avoid breaking the tabs shown on
Figure A.
2. Remove the suction cups from the shroud mounting brackets.
3. Install each suction cup to each bracket using the existing screws as shown on
Figure D.
4. Insert bracket as shown on Figure B.
5. Clean mounting surface with supplied alcohol wipe.
6. Apply the product on to the treated surface gently pressing the suction cups on to the
glass. Apply light pressure for 20 seconds. Gently adjust the light head to its desired
angle if needed.
7. Insert the provided screws in the light head locking mechanism as shown in Figure C.
This will hold the brackets in position & the light head in the desired angle.
MOUNTING WITH HARDWARE (HARDWARE NOT PROVIDED):
1. Carefully remove the light head from the shroud.
CAUTION: gently release the locking tabs to avoid breaking the tabs shown on
Figure A.
2. Insert the light head bracket as shown on Figure B.
3. Hold the product to desired location. Adjust the light head to its desired angle
by adjusting the bracket.
4. Clean mounting surface with supplied alcohol wipe.
5. Install product on to the treated surface by using #8 hardware screw (not
included) as shown on Figure E.
6. Insert the provided screws in the light head locking mechanism as shown in Figure C.
This will hold the brackets in position & the light head in the desired angle.
FIGURE 6
FIGURE 7
FIGURE 8
** MOUNTING HARDWARE NOT PROVIDED
*For extra adhesion, use 3M Tape Primer. For product & application information, go to: https://multimedia.3m.com/
mws/media/65952O/3mtm-tape-primer-94.pdf
