15
Rear Panel
Power Inlet
The C5 amplifier should be connected to a suitable mains electricity supply using the cable
supplied. The unit uses auto ranging switch mode power supplies which are capable of
operating with a nominal mains voltage of either 115V or 230V, 50/60Hz without re-
configuration.
Audio Input Connectors
All audio connections are fully balanced and wired pin-1 ground, pin-2 hot & pin-3 cold.
The two inputs have pin-1 connected directly to the chassis and feed the signal processing
chains. If an unbalanced source is used, a connection should be made between the pin-3
‘cold’ signal and the ground connection of the unbalanced source.
Audio Output Connectors
Each amplifier pair has two speaker outputs.
There are two Neutrik Speakon
TM
connectors for each amplifier pair:
Speakon 1 (or 3) carries both channel 1 (or 3) and channel 2 (or 4) outputs
Speakon 2 (or 4) carries channel 2 (or 4) output
For non-bridge connections, use Speakon 1 (or 3) for the first speaker, and Speakon 2 (or
4) for the second speaker. Use pins 1+ and 1-.