AWMR-210 MINI BUILT-IN DIMMER/SWITCH
8
Remarks
Reminders
•
This product is suitable for installation in a wall box, behind the existing wall switch, and must be used
in combination with at least one COCO transmitter.
•
The wall box must have depth of at least 40 mm.
•
This product is a dimmer/receiver: control lights (or other suitable devices) remotely, without
complicated wiring. You can continue to use the existing wall switch for manual operation.
•
Dimming with the existing wall switch: (1) Switch on the light. (2) Quickly switch the light off and on with
the wall switch. The light intensity changes continuously. (3) Switch off the light when it reaches the
desired intensity. The most recently selected light intensity will be remembered.
•
To prevent interference, avoid placing multiple products close to each other. The minimum distance
between units should be approx. 50 cm.
•
The wireless system can be expanded indefinitely with other COCO remote controls and/or receivers.
•
Your COCO transmitter may have a special "group" button with which you can simultaneously control
multiple receivers with different numeric codes. Repeat
[7 - 8]
and press the "group" button on the
transmitter during step
[8]
.
•
To delete one stored code: (1) Briefly press the connect button. (2) Press the "off" button of the code
you want to delete from the memory. (3) To confirm, the dimmer switches on and off two times.
•
To delete all the stored codes (resetting the memory): (1) Hold in the search mode button. (2) The
indicator begins flashing after approx. 7 seconds. (3) Release the button. (4) Briefly press the search
mode button again. (5) To confirm, the dimmer switches on and off two times.
•
If the product does not work:
- Reset the memory (see previous line) and set the code from the transmitter again (repeat
[7 - 9]
).
- Check whether the indicator is lit; if not, there may not be any power to the product or the electronic
fuse may have blown (in the latter case the product must be replaced).
