AWMR-210 MINI BUILT-IN DIMMER/SWITCH
Safety instructions
•
Wa rning: Even if the product is switched off, voltage may still be present at the switched socket!
•
Never use COCO products for life support systems or other applications in which equipment
malfunctions can have life-threatening consequences.
•
Do not connect any lights or other equipment that consume a total of less than 40 Watts or more than
210 Watts. Connecting incorrect equipment can cause defects, a short circuit and fire.
•
Only connect equipment that is suitable for dimming.
•
Only connect incandescent lamps or 230 Volt halogen lamps. This product is not suitable for low-
energy light bulbs or fluorescent lighting.
•
Do not connect any lights or devices that require a transformer.
•
This product has an electronic fuse that automatically interrupts the power in the event of a short circuit,
overload (more than 2 A) or at a temperature above 130 °C. If this occurs, the product must be
replaced. A defective electronic fuse is not covered by the warranty.
•
Do not expose this product to excessive heat, direct sunlight or moisture.
•
Do not attempt to repair this product. If the product is damaged or if you are in doubt about the proper
operation, take the product back to the place of purchase.
•
Do not use the product in damp areas. Clean the device with a clean cloth.
Wireless
•
This product works using a radio signal that passes through walls, windows and doors. The range is
maximum 75 metres in the open air. The range indoors is strongly influenced by local conditions such
as concrete, glass and metals. On average, the indoor range is approximately 30 metres.
•
New double glass often includes a thin metallic layer. This type of glazing (“
HR glass
”) allows most
visible light to pass through but has a negative impact on radio signals. If there is HR glass between the
transmitter and receiver, you should expect a significant reduction of the range of the wireless signal.
•
This product operates at a frequency of 433.92 MHz. It complies with the essential requirements and
other conditions of R&TTE Directive 1999/5/EC and can be used in all EU countries.
•
There may be restrictions on the use of this device outside the EU. If this device is used outside the EU,
check whether the device complies with the local directives.
9
