Cochran COMMANDER, Руководство пользователя

Страница: 15 / 44

1 3
NOTE: Once a value has been changed and the
next menu option selected, the new value
is stored.
NOTE: It is strongly recommended that the
Programming Mode is activated again and
a complete review of what was stored is
accomplished.
NOTE: If the COMMANDER is left in the
Programming mode for five minutes
without the contacts being touched, the
unit will automatically exit the
Programming Mode and return to the
Surface Interval. Once this occurs the
COMMANDER will retain the modified
programmed settings that have been
stored. Options that have not been
modified will retain their previous settings.
TOUCH PROGRAMMING MODE - PROCEDURE:
Contacts 1, 2, & 3 are for programming sequences.
To begin the programming sequence:
1. Turn the unit on;
2. Using a coin or other conductive metal object,
briefly bridge Contacts 1 and 2 until a short beep
is heard and the Programming Menu is seen on
the display. The Programming Menu options
depend on whether the unit is activated for Clock.
The Menu options are displayed in sequence,
incrementing to the next selection each time that
Contacts 1 & 2 are bridged with a
coin . The
program option is displayed on the upper row of
the display. The current setting for this option is
displayed in the lower right of the display.
3. To reprogram the displayed menu values, bridge
Contacts 1 & 2 with wetted fingers. This will
cause the current setting to flash or in the case of
multi-digit numbers, the least significant digit will
flash. The clock will toggle between on and off.
4. Using a coin or other conductive metal object,
bridge Contacts 2 & 3 to increment the numeric
value. A confirmation beep will sound with each
increment.
5. Next using wetted finger, bridge Contacts 1 & 2 to
select the next digit, once selected the digit will
flash to identify that it is being programmed.
Bridge Contacts 2 & 3 till the desired value is
displayed.
6. Repeat step 5 until all digits have been
programmed.