COMPLETE INSTRUCTIONS G100-G300
49
6.7 - Arming
6.7.1 Arm by means of the vehicle’s original radio controls
•
When the lock button on the original radiocontrol is pressed, the doors lock and
the system is armed.
•
The buzzer emits two acoustic signals (if enabled).
•
The LED lights up and stays on for
25
s, then flashes.
•
The protection functions activate after
25
s.
6.7.2 Arm with Driver Card
It is also possible to connect the alarm system in the event of an emergency by pressing
the button on the Driver Card, without locking the doors.
6.8 -
Disarming (using the Driver Card).
Introduction: the alarm is disconnected using the vehicle’s original remote control and by
recognition of the Driver Card as follows:
6.8.1 -
original radiocontrol recognition procedure.
•
Press the original radiocontrol button to unlock the doors.
•
The direction lights flash (“pre - disarm” phase).
•
The protection functions are temporarily deactivated while awaiting the
Driver Card signal.
•
The buzzer emits an acoustic signal (if enabled). Once the Driver Card
has been recognised, the LED switches off.
Note:
it is also possible to disarm the alarm system in the event of an emergency by
pressing the button on the Driver Card, without unlocking the doors.
6.9 - Deactivating the ultrasonic volumentric sensor.
If you wish to arm the protection system with the windows lift open or when a
passenger will be staying inside the passenger compartment, it is possible to deactivate
the volumetric sensor so that it will not generate any alarms.
•
Within 5 s after having turned off the ignition and from the door opening, keep the
button pressed down until you see the LED give a long flash. If a hyperfrequency
or anti-lifting sensor is installed, it is possible to disarm it by pressing the button
again within 5 s after the LED has flashed. The LED will flash again to confirm its
deactivation.
•
Arm the system by pressing the radiocontrol button: the sensors are deactivated
but all the other protections are active. The sensors will be automatically reactivated
the next time the ignition is turned on.
