COMPLETE INSTRUCTIONS G100-G300
50
6.10 - Driver card Function.
The Driver Card is used exclusively for the user recognition phase:
When the doors are unlocked by the vehicle’s original radiocontrol the system goes into a
“pre-disarm” phase which lasts for 25 s, activated by the opening of a door.
When 25 s have elapsed after the door opened, unless Driver Card recognition has
occurred an alarm state is generated. It is possible to disarm the system during the alarm
phase using the Driver Card key or by keying in the entire Pin Code from the LED panel
(see page 72).
G100 - G300
6.11 - Protection functions.
When the system is armed, opening the bonnet/boot/door or attempting to start the vehicle
generates an acoustic and visual alarm cycle that lasts approximately 30 s. In products
that include a volumetric sensor, the alarm will be triggered off by intrusion into the
passenger compartment. At the cycle’s end the system stays armed.
6.12 -
Coupling of modules / siren 4310 / satellite alarm ICD31 on Cobra Bus
line.
On the Cobra Bus line (pin 14) it is possible to connect the following additional modules
(Siren 4310 / anti-lifting module / satellite alarm ICD 31 / Engine lock 8509) by means of the
following programming procedure:
1.
Disconnect system.
2.
Enter programming mode using the dedicated procedure for the product.
3.
Move from page 1 to page 7 by activating and de-activating the panel (+15 ON /
OFF).
4.
The storage and completion of programming is signalled by flashing indicator
lights.
Repeat from point 1 if a module of the Cobra Bus line is disconnected.
NOTE
: with the alarm disconnected, disconnecting a self learning module from
the Cobra Bus line, when the G100/G300 is armed the indicator lights will flash
8 times and if the Buzzer is activated it will signal 8 times by the buzzer.
ATTENTION!
If both radiocontrol devices (G100) or Driver Card (G300) have been lost, proceed
as follows
:
A.
Disarm the system by keying in the PIN code.
B.
Cut off the system’s power feed (disconnnect the connector from the central
unit).
C.
Open a door and the vehicle’s bonnet.
D.
Turn on the ignition.
E.
Reconnect the power feed.
