DIGIMINI EMEA/APAC/AUSTRALIA REPEATERS
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless
–
Coverage
Date: 11-Oct-15
www.cobham.com/wireless
Document number: 00030UMCD
Rev. 5.0
Page |
3-7
3.6 Antenna Connections
CAUTION!!
•
Do not connect the antenna cables to the Repeater before verifying the installation parameters.
•
Do not power-up the Repeater without either the antennas being connected or the antenna
connections terminated with dummy loads. To connect the antennas to the Repeater
To connect the antennas to the Repeater
NOTE: If the coaxial cables are NOT weather-resistant type, wrap the exterior coaxial cables with
insulation and holding tape (Type 3M Rubber splicing tape) for environmental protection and to
ensure longer lifetime.
1. Install the antenna cables along their path to the Repeater, and connect them to the Antennas.
NOTE: Be sure to use low loss cables.
2. Connect the Donor antenna to the Repeater BASE port. (Donor antenna specifications and
installation criteria are described in section
3. Connect the Service antenna to the Repeater MOBILE port. (Mobile antenna specifications and
installation criteria are described in section
4. Verify all RF connectors are tightened and the cables and antennas are secured.
Figure 3-5. Antenna Connections
Mobile
Base