252 Owner’s Manual
3-37
O
PERATING
I
NFORMATION
A “Y” valve is installed between the pump-out plate
and the macerator thru-hull fitting. The macerator
pump is located between the “Y” valve and the
macerator thru-hull fitting. In this configuration all
waste is flushed from the head to the holding tank.
The “Y” valve permits you to use the dockside
pump-out feature, or to use the macerator to pump
the waste from the holding tank overboard.
To pump out the holding tank using the macerator
pump:
1. Move the “Y” valve lever to the DOWN or
OVERBOARD position.
2. Activate the macerator pump by turning its
switch on.
3. Turn macerator pump off after the pump-out is
complete.
If your boat is equipped with a tank level monitor,
the tank level monitor will illuminate the indicator
lights to monitor the tank level.
BOW TONNEAU COVER -
OPTIONAL
Follow these procedures to attach the bow tonneau
cover:
1. Open walk-thru doors.
2. Starting at bow, slip bow opening over bow,
work aft, and snap the cover to the boat.
3. Close windshield center door and snap the
canvas to the underside of the windshield.
4. Install the adjustable tonneau cover support
pole. Make sure the pole is perpendicular to the
floor and adjust to “tent” the cover.
5. Walk-thru doors may be closed if desired.
Do not use bow tonneau cover for extended
storage. It is not designed for storage, but can be
used for overnight storage or trailering.
COCKPIT TONNEAU COVER -
OPTIONAL
Follow these directions for the cockpit tonneau
cover.
1. Unroll the cover and snap to the deck, starting
at the center of the windshield. Snap to the
forward outside edge of the windshield only.
2. Install tonneau support pole(s) to underside of
the cover (just in front of rear seat) with snap
and adjust pole to approximate height of
windshield. Some models have two support
poles. Make sure the poles are perpendicular to
the floor and adjust to “tent” the cover.
3. Pull elastic cords over discs on transom,
starting in the center and working outboard (you
may have to readjust the support poles for
proper fit).
4. Continue snapping up the sides.
5. The walk-thru doors may be closed if desired.
Do not use cockpit tonneau cover for extended
storage. It is not designed for storage, but can be
used for overnight storage or trailering.
NOTICE: Always double-check
snaps are secure.
NOTICE: Always double-check
snaps are secure.
COB_01
38
_A
COBAL
T
BOW TONNEAU
(BOW RIDER
S
ONLY)
COCKPIT
TONNEAU
COB_252_OM.book Page 37 Tuesday, April 15, 2008 11:44 AM