3-34
252 Owner’s Manual
COBALT
252
B
OWRIDER
S
ECTION
3
ANCHOR LIGHT
To install anchor light insert pole into socket and
turn clockwise until it locks into place.
Cap the anchor light socket when the anchor light is
removed.
CRUISE CONTROL -
OPTIONAL
To operate the Cruise Control speed control
system, set desired speed. Once your boat reaches
the set speed, the Cruise Control will hold the
speed constant. For additional operating
information, refer to Cruise Control operator’s
manual in your owner’s packet.
BATTERY SWITCH
The single and/or optional dual battery switch
provides isolation and positive disconnect from the
battery or batteries to protect against tampering,
electrical fire hazards and battery rundown. Battery
selection should be done when the engine is off
(alternate battery usage daily). Switch to the
“primary,” “secondary” or both batteries. Under
normal conditions, the switch should be in the ON
position for one battery rather than the ON position
for both batteries. This will keep one battery in
reserve should the other fail. You can operate the
boat with the switch in the “both” position, but this is
not recommended for extended periods. In the OFF
position, the boat will be isolated from the batteries,
except for the automatic bilge pump.
WATER SYSTEM
If your Cobalt boat is equipped with a transom
shower (optional), the system allows for potable
(drinkable) water to be stored onboard for the
transom shower. Refer to
Section 1
,
Specifications
, for the capacity of the water
system.
The system is operated by a 12V DC water pump
located in the engine compartment. It is necessary
for the 12V DC system to be energized and the
WATER PRESSURE switch to be turned on to
operate the water system. The water pump works
on demand. It will not automatically shut off when
the freshwater tank is empty.
A
WARNING
Avoid injury or death. DO NOT use the
cruise control feature as a means for
navigation or for “no hands” operation.
COB_0097_A
ON/OFF
MENU
PERFECTPA
SS
WAKEBOARD PRO
WAKBD 22 . 5 22 . 5
COB_0029_A
NOTICE: The purpose of dual
batteries is to keep one as a
spare. In the “both” position,
you essentially have one larger
battery and if a failure should
occur with the electrical
systems or either battery, both
batteries will end up discharged.
COB_252_OM.book Page 34 Tuesday, April 15, 2008 11:44 AM