HANDBOOK (V
4.0)
COMPLETE CONTROL SYSTEM GEN2
21
In the Complete Control Kit
The
Complete Control
System Gen2 kit contains the following components:
1.
Complete Controller
main processor
2.
EMG Interface Cable (clinician-specified termination type)
3.
Device Interface Cable (clinician-specified termination type)
4.
Complete Calibrate
button (part of Complete Controller)
5.
Socket cut-out template for the
Complete Calibrate
button
6.
Fabrication Aid (disposable mock-up of
Complete Controller
)
7.
Complete Communicator
USB Bluetooth Dongle
Placing the Complete Control system
The main processing unit of the Coapt system is the
Complete Controller
. Permanently attached to that is the
Complete Calibrate
button. That button is designed to be secured into the outer socket wall of the prosthesis
with its button side exposed to the user. You can make good use of the provided fabrication aids to ensure the
Complete Controller
and the
Complete Calibrate
button fit perfectly.
The
Complete Controller
main unit arrives in its box with two cables already attached. One should have white
sleeving and the other gray sleeving. If you have not already, feel free to detach those cables for easier
fabrication. The logo on one side and some instructive arrows on the other side will help you make sure you will
reattach them correctly. These are unique and keyed connectors which also helps.
No access is required for everyday use of the
Complete Controller
and it can be placed accordingly during
prosthesis fabrication. Avoid excessive compression of the unit and attempt to locate the
Complete Controller
away from impact or load-bearing areas of the prosthesis.
The
Complete Controller
has two main lobes connected by a semi-flexible bridge. This allows for the unit to
conform to the curvature of a prosthetic socket or be folded to fit in distal socket voids. Take care not to cut or
damage the flexible bridge with sharp elements.
1
2
3
4
5
6
7