8
EN
GL
IS
H
1
3
10
12
13
9
11
1
Attaching accessories
Warning:
Turn the grinder off and unplug it before attaching any accessories.
1. Press in the spindle lock button (3)
and undo the collet chuck (1).
2. Insert an accessory into the chuck and then
tighten the chuck. The collet (10) might need
to be changed depending on the shank
diameter of the accessory. Two collets are
supplied: 2.4 mm and 3.2 mm.
Attaching flexible drive shaft
Warning:
Turn the grinder off and unplug it before attaching any accessories.
1. Unscrew the nose collar (2). Pull the drive wire (11) a short way out of the flexible
drive shaft (9) and grip the end of it in the 3.2 mm collet chuck (1).
2. Screw the flexible shaft to the thread on the machine where the nose collar was.
3. Lock the flexible drive shaft by inserting the spindle
lock pin (12) into the hole on the nose.
4. Undo the flexible drive shaft’s collet chuck (13)
and insert the desired accessory before tightening
it again.
Содержание DM-160B
Страница 2: ...2...
