Operating Instructions
RaptorX-SL-Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 21
Support: +49 (0)2831/91021-50
06.10.2010
Responsibility of the Operator
The machine is used in the commercial sector. Therefore the
operator of the machine is subject to the statutory requirements
for operational safety.
In addition to the safety instructions mentioned in this manual
the valid safety regulations and rules for accident prevention as
well as the environmental protection law have to be observed.
In particular the following must be adhered to:
The operator has to be informed about the valid industrial
safety regulations and an evaluation of possible additional
dangers may need to be done to determine any further
potential hazards in order to enhance the safety of working
conditions at place of operation.
During the entire operating time of the machine the operator
has to verify that the Standard operating procedures (SOP)
prepared by him or his company are in accordance with the
current regulations and adjust them if necessary.
The operator has to clearly define and regulate the
responsibilities for installation, operation, maintenance and
cleaning.
The operator has to ensure that all staff who deals with the
machine have read and understood the instruction manual. In
addition, the staff must be regularly trained and informed
about the dangers.
The operator has to provide the necessary protective
equipment for the staff.
The operator is responsible for installing circuit breakers on
doors or any other movable devices. Limit switches have to
be installed on any movable safety devices as well as on any
doors and they must be integrated into the control system.
Only after this has been completed can we supply a CE
Declaration instead of the manufacturer’s declaration.
If a security fence or protection has been installed
as per the instruction manual, a CE certificate may
be supplied with the machine in place of a
manufacturer’s declaration.
