7
MOUNTING THE RELAY HARNESS
WARNING!
Do not connect relay harness to battery until entire assembly and controls are
mounted and ready. Severe damage to pump and controls could occur.
A.
Find suitable place to mount relay harness. A dry place, typically the rear compartment is
recommended.
B.
Mount relay harness using mounting holes located on relay harness bracket. Drill holes and bolt
relay harness securely in place.
WARNING!
When drilling the holes,
BE SURE
not to drill through the hull or side wall.
INSTALLATION OF ROCKER CONTROL SWITCH
CAUTION!
Before cutting any holes in mounting
surface check area behind mounting surface for obstructions.
(Cable braces, wiring, etc.)
DRILLING TIPS:
If mounting surface is fiberglass, apply masking tape to the surface that is to be cut to prevent
mounting surface from chipping or cracking. If the mounting surface is vinyl covered, remove the
vinyl from the surface to be cut using a razor blade to keep vinyl from tearing.
NOTE:
The toggle control switch can be flush mounted or surface mounted depending on location
chosen. In either case, the toggle control switch should be positioned within easy reach of the boats
operator and within reach of the motor lift pump relay harness.
