CMi 466957, Руководство по эксплуатации

Страница: 60 / 213

8. Control elements
60
466957 V_01/06/2010
GB
7.10. Changing the table insert (Figure 16)
To prevent increased likelihood of injury the table insert (17) should be changed whenever it is worn
or damaged.
• Detach the table (15) (see 7.1).
• Lift out the worn table insert (17).
• Fit the replacement table insert by following the above in reverse.
7.11. Extractor sockets
The bandsaw is equipped with extractor sockets (6) for extracting sawdust and chips.
8. Control elements
8.1. On/Off switch (Figure 17)
• To turn the machine on, press the green button „1“ (g).
• To turn the machine off again, press the red button „0“ (h).
• Your bandsaw has a switch with undervoltage release. After a power failure you must reactivate
the switch.
8.2. Parallel stop (Figure 18)
• Push the clip (21) on the parallel stop (24) upwards.
• Move the parallel stop (24) along the table (15), from either the right or left of the blade (26),
and position as required.
• Push the clip (21) down to fix the parallel stop (24). If the clip (21) does not give enough hold,
turn it clockwise several times until the parallel stop is securely fixed.
• You must always ensure that the parallel stop (24) is positioned parallel to the blade (26).
8.3. Angular cuts (Figure 19)
To enable you to perform angular cuts parallel to the blade (26), the table (15) can be tilted forwards
between 0° – 45°.
• Undo the fixing handles (18).
• Tilt the saw table (15) forwards until the required angle value is set on the dial scale (16).
• Re-tighten the fixing handles (18).
• Important: When the table (15) is tilted, place the parallel stop (24) to the right of the blade (26)
looking in the direction in which you are working, on the side pointing downwards (provided the
workpiece is wide enough) in order to stop the workpiece from slipping off.
9. Operation
• For all cutting operations it is important to position the blade guide (11) as close as possible to
the workpiece (see 7.5).
• Always guide the workpiece with both hands, holding it flat on the table (15) in order to prevent
the blade (26) from jamming.
Attention!
Caution!
After every new adjustment we recommend you to make a trial cut in order to check the
new settings.
466957.book Seite 60 Donnerstag, 17. Juni 2010 8:53 08