9. Ordering replacement parts
38
466789
V_01/06/2010
GB
8.1 Cleaning
• Keep the safety devices free of dirt and dust as far as possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low pressure.
• We recommend that you clean the appliance immediately after you use it.
• Clean the appliance regularly with a damp cloth and some soft soap. Do not use cleaning
agents or solvents; these may be aggressive to the plastic parts in the appliance. Ensure that
no water can get into the interior of the appliance.
• You must disconnect the hose and any spraying tools from the compressor before cleaning. Do
not clean the compressor with water, solvents or the like.
8.2 Condensation water
The condensation water must be drained off each day by opening the drain valve (11) (on the floor
of the pressure vessel).
8.3 Safety valve (10)
The safety valve has been set for the highest permitted pressure of the pressure vessel. It is prohib-
ited to adjust the safety valve or remove its seal. Actuate the safety valve from time to time to ensure
that it works when required. Pull the ring with sufficient force until you can hear the compressed air
being released. Then release the ring again.
8.4 Cleaning the intake filter (13)
The intake filter prevents dust and dirt being drawn in. It is essential to clean this filter after at least
every 300 hours in service. A clogged intake filter will decrease the compressor’s performance dra-
matically. Remove the filter from the compressor by unscrewing the screw on the plastic cover (J)
(Figure 6). Lift off the plastic cover (J) and remove the intake air filter (13) underneath (Figure 7).
Carefully clean the filter by tapping and blowing it with low pressure compressed air (aprox. 3 bar).
To assemble, proceed in reverse order.
8.5 Storage
9. Ordering replacement parts
Please quote the following data when ordering replacement parts:
• Type of machine
• Article number of the machine
• Identification number of the machine
• Replacement part number of the part required
For our latest prices and information please go to www.isc-gmbh.info
Attention!
Important!
Pull the mains plug out of the socket and ventilate the appliance and all connected
pneumatic tools. Switch off the compressor and make sure that it is secured in such a
way that it cannot be started up again by any unauthorized person.
Attention!
Important!
Store the compressor only in a dry location which is not accessible to unauthorized per-
sons. Always store upright, never tilted!
466789.book Seite 38 Mittwoch, 16. Juni 2010 11:05 11
