6. Assembly and starting
37
GB
466789
V_01/06/2010
6. Assembly and starting
6.1 Fitting the wheels (3)
Fit the supplied wheels as shown in Fig. 3.
6.2 Fitting the supporting foot (4)
Fit the supplied rubber stopper as shown in Fig. 4.
6.3 Voltage
The compressor is equipped with a mains cable with shock-proof plug. This can be connected to
any 230 V~ / 50 Hz shock-proof socket which is protected by a 16 A fuse. Before you use the
machine, make sure that the mains voltage complies with the specifications on the rating plate.
Long supply cables, extensions, cable reels etc. cause a drop in voltage and can impede motor
start-up. In the case of low temperatures below +5 °C, motor start-up is jeopardized as a result of
stiffness.
6.4 On/Off switch (8)
To switch on the compressor, pull out the knob (8).
To switch off the compressor, press the knob (8) in again. (Fig. 2)
6.5 Adjusting the pressure: (Fig. 1)
• You can adjust the pressure on the pressure gauge (6) using the pressure regulator (7).
• The set pressure can be taken from the quick- lock coupling (5).
6.6 Setting the pressure switch
The pressure switch is set at the factory.
Switch-on pressure 6 bar
Switch-off pressure 8 bar
7. Replacing the power cable
If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its
after- sales service or similarly trained personnel to avoid danger.
8. Cleaning and maintenance
Attention!
Important!
You must fully assemble the appliance before using it for the first time.
Attention!
Important!
Pull the power plug before doing any cleaning and maintenance work on the appliance
Attention!
Important!
Wait until the compressor has completely cooled down. Risk of burns!
Attention!
Important!
Always depressurize the tank before carrying out any cleaning and maintenance work.
466789.book Seite 37 Mittwoch, 16. Juni 2010 11:05 11
