CMA Dishmachines CMA-180UC, Руководство по обслуживанию и запасным частям

Страница: 14 / 41

MODEL CMA-180UC SERVICE & PARTS MANUAL Rev. 1.18B
Page
12
2.2.7. Booster Heater Setup
The booster tank must be filled with water before the heating element is energized.
For this reason the “High Limit Switch” has intentionally been disconnected at the
factory and will require re-connection before the heating element will turn on.
Follow the procedure below to complete the initial installation:
1. Close the door on the machine.
2. Turn the Power switch to the "ON" position.
3. Hold the “FILL” switch in until water overflows into the scrap tray.
4. Turn the Power switch to the "OFF" position.
5. Connect blue wire with disconnect, identified by red tag, to the High Limit
Switch which is located behind the thermostat behind the front kick panel.
2.2.8. Installers Checklist
 Dishmachine checked for concealed damage
 Hot water supply is 140° F (60 C) — minimum
 Incoming water supply line is ½” — minimum
 Incoming water supply is 6 GPM minimum at 24 PSI
 Supply circuit breaker for machine is properly sized (50 amp)
 Service voltage and phase type are correct to machine data plate
 If drain pump is used, drain hose rises 12 to 16” before dropping to drain
 Drain hose is installed with air gap (discharge 1” above drain)
 Optional detergent and rinse dispenser (if present) is properly installed
 Dishmachine is properly grounded
 Dishmachine is properly leveled
 Machine circuit breaker is labeled “DISHWASHER”
 Machine has been “hard-wired” with correctly sized wire

Booster tank has been filled with water (before High Limit Switch is reset)
 High Limit Switch for heater has been reset (after Booster Tank has been filled)