CM VERSA CLIMBER, Руководство по эксплуатации

Страница: 18 / 24

Page 15
Step 11.
Mark the three holes on the centerline. Re m ove your
VC and place to the side. Drill the three holes using
1/2” ce
m ent drill bit at least 1 inch deep.
Step 12.
Tap in the three lag shields supplied. Place the VC
back in place aligning the three holes secure with
three 5/16” lag bolts plus washers supplied.
Step 13.
Your VC is now secure to wall. You can adjust your VC
closer or farther fro
m the wall to avoid s m all obstruc-
tions. The closer your VC is to the wall the m ore sta-
ble it will be. Adjust your VC if necessary. Deter m ine if
the base needs to be secured to the floor for extra sta-
bility. Cli
m b on your VC to see if the base m oves. If
you want to secure to the floor, continue to next step.
Step 8.
Mounting your VC to ce m ent wall. Mark a line hori-
zontally 85 inches fro m the floor.
Step 9.
Attached the brack-
et to you VC using
the four bolts,
washers and nuts
supplied, centering
the four bolts to
allow adjust
m ent
forward and back-
wards.
Step 10.
Stand your VC up and rest the bracket against the
wall. Place the holes of the bracket on the center line
you have
m arked on the wall. The front base holes on
the VC should be approxi m ately 38 inches fro m the
wall. This distance m ay vary depending on the wall,
base boards, and or where the bracket is positioned.
THE CENTERLINE
2”x 6” Board
85 inches from
the ground is
the centerline
Keep spacing at least 40” apart.
Bolts centered in brackets.
NOTE:
Before mounting to wall, make sure brackets are centered
to allow forward and backward adjustment from wall.
THE CENTERLINE
NOTE:
For multiple units side by side, spacing should be a minimum of
40” from the center of the vertical center line of each unit.
40”