Club Car Precedent 2004, Техническое обслуживание и сервис

Страница: 54 / 212

WHEEL BRAKE ASSEMBLIES Brake Cable Removal and Installation
Page 6-12 2004 Precedent IQ System Golf Car Maintenance and Service Manual
6
Brake Cable Installation
NOTE: The driver-side and passenger-side brake cables are not interchangeable. The driver-side cable is
shorter than the passenger-side cable. Make sure the correct cable is used on the correct side.
Be sure to orient the cable so that the clevis end goes to the wheel rather than to the equalizer
bracket.
1. Insert the end of the new brake cable through the hole in the frame (Figure 6-19, Page 6-11) . Push on
the cable housing so the clips on the housing ends secure the housing in the hole.
2. Hold the lag bolt (5) and the equalizer bracket (4) in the upright position and slip the cable head through
the hole on top of the bracket. Pivot the equalizer to the horizontal position to capture the cable heads
in the equalizer.
3. Insert the rear cable housing into the shock mount bracket (4) (Figure 6-20, Page 6-12) . Push the cable
housing end into the bracket to ensure the clips on the housing end secure the cable in position.
4. At the rear wheel brake, connect the cable to the brake actuator arm using new clevis pin (2) and new
bow tie locking pin (1) (Figure 6-20, Page 6-12) .
5. Place tab (3) on cable housing over the forward leaf spring mounting bolt (2) (Figure 6-21, Page 6-12) .
Install nut (1). Tighten nut to 18.4 ft-lb (25 N·m).
6. Adjust the brakes. See Brake Cable Equalizer Adjustment on page 6-8.
Figure 6-20 Disconnect Cables at Rear Brakes Figure 6-21 Brake Cable Mounting Tab
2
3
1
4
AS SEEN FROM
DRIVER-SIDE OF
VEHICLE
REAR OF VEHICLE
1
2
3